Now is as good a time as any to get those niggling DIY jobs done. But before you get your toolbox out, find out how to successfully avoid the most common DIY mistakes.
Amateur mistakes are all too easy to make, and can be very time-consuming, so here is a list of the top ten most common, and how to avoid them. From how to paint skirting boards to using primer, we talk you through how best to avoid making a mistake.
1. Have a spirit level to hand
Putting up a shelf should be a five-minute job, but saving time by not using a spirit level could cause all manner of problems later, when ornaments fall over or books slide off. Use a spirit level to establish a level edge (when the bubble sits exactly in the middle of the window), then use a pencil to draw a guideline to work by.
2. Use primers
Watermarks can be a pain to cover up. Painting over the stain with a water-based emulsion won’t help; the stain will keep showing through, however many coats you use. Apply an oil-based primer paint or spray over the stain to seal it, and then you can cover it with any paint and colour you choose.
3. Think ahead
Bespoke panelling around a bath and toilet give a bathroom
a clean finish, but bear in mind that, inevitably, there will be the
odd leak, and you will need access to the pipes to fix them. It’s easy
to plan one removable panel or concealed door for this purpose, and this
will give you a place to hide the spare toilet rolls and soap as well.
MPU 01 Desktop
MPU 01 Mobile
4. Avoid quick fixes
After wet weather, wooden doors become swollen and stick in the frame.
Planing the wood is an instant fix, but be sure to paint over the
exposed edges with an oil-based primer as well. If the wood is not
sealed like this, it will continue to absorb moisture and swell up –
leaving you to do the job all over again.
5. Don’t scrimp on essentials
There’s no point in buying expensive paintbrushes for one job, but steer
clear of budget brushes. These have fewer bristles, which make an
untidy finish, and they moult more than a mid-range brush, so you will
be constantly picking bristles out of the paintwork. Synthetic brushes
are fine for the DIYer, and they keep their shape, while natural
bristles tend to splay out after use.
6. Protect surfaces
Painting a skirting board can be a painstaking job as you try to keep the paint away from the carpet.
The obvious solution is to pull back the carpet edge; this is not
always practical, but spending five minutes fixing masking tape along
the edge of the carpet will do the trick. If you are staining a wood
skirting board, remember to protect the joining wall with tape too.
7. Support your shelves
When putting up shelves and pictures on a partition wall, you must
locate the weight-bearing studwork behind the plaster for support, or
screws and nails will come out under the slightest weight. These wooden
posts, which are the backbone of the wall, may not always be where you
want your nail to go, but in this case, you can always use cavity
fixings, which anchor screws and nails into the plaster. These are
available from most DIY stores and websites.
8. Don’t under-estimate materials
If you are wallpapering with a patterned design, you will need to take
this into account when buying. If the repeat is much more than 55cm, you
will need extra rolls, as there will be more waste when cutting the
paper to join up the pattern. Make sure the rolls have matching batch-
and shade-numbers, and remember that off-the-shelf wallpaper can usually be returned if unopened, but most mail-order companies do not accept returns.
9. Prepare thoroughly
Always clean walls
and skirting boards before you start painting, vacuuming rather than
sweeping, as any dust floating around will stick to wet paint and ruin
your hard work. Keep dust sheets down until you are sure all the paint
has dried, especially gloss, but be careful with sheets on wooden
floors, as they will slide around and can be dangerous.
Ideal Home newsletter
Sign up to our newsletter for style and decor inspiration, house tours, project advice and more
10. Less is more
Lastly, whether it’s wood, wallpaper or carpet, check and double-check
every measurement before making a cut – you can always take more off,
but if you cut too short you have wasted your time, your material and,
most importantly, your money.
Need some DIY help? Hire a tradesman today with our handy tool!